Score:0

HP ProLiant DL380p Gen8 raid swap

in flag

We have a HP ProLiant DL380p Gen8 which boots vmware and loads 3 windows virtual servers. We started getting cyclic redundancy erros during backup and then one of the raid drives started showing red on it's push button release. I ordered a new drive and hot swapped it this morning. The new drive appears to be acting the same as the old drive. I tried to download a gui to see the raid status but everything I have tried says it will not run in virtual machine. I am afraid to power the machine down as I have read here that doing so could lose the array. Is there a way to tell if it is rebuilding?

thanks mlc

Brandon Xavier avatar
us flag
Assuming VMware was installed using an HPE customized image (it probably was), you should have the Smart Storage Admin CLI utility available at the ESXi host level. That will give you all the information and commands available from a GUI in CLI form.
Zac67 avatar
ru flag
The RAID status should also show up in iLO, but that may be limited in Gen8.
Score:0
cn flag

You can (generally speaking) not access local hardware from within a virtual machine. The "only" job of a hypervisor ist total separation from the host's hardware. So you will have to use hardware tools (for example HPE's Smart Storage Administrator) directly on your host.

You can boot the DL380 directly into one (booting from a Support Pack ISO through iLO or USB) without any installation or download it for your specific hypervisor and install it there.

I am afraid to power the machine down as I have read here that doing so could lose the array.

From your description this is unlikely, however just make a backup copy of your VMs before rebooting the host.

mangohost

Post an answer

Most people don’t grasp that asking a lot of questions unlocks learning and improves interpersonal bonding. In Alison’s studies, for example, though people could accurately recall how many questions had been asked in their conversations, they didn’t intuit the link between questions and liking. Across four studies, in which participants were engaged in conversations themselves or read transcripts of others’ conversations, people tended not to realize that question asking would influence—or had influenced—the level of amity between the conversationalists.