Score:0

How to inspect outgoing traffic from Acess Point

cn flag

I have Access Point which is connecting to VPN and create internal WiFi network of our company everywhere. Now I need to inspect what protocol for VPN is this AP using. I am not able to configure it, so I need to inspect this from packets which is AP sending outside. I would like to run something like wireshark on this AP and watching for outgoing traffic, but it is not so easy and I am not sure how can I do it. I was thinking about something like that - I can connect my PC to WAN port of this AP, and maybe I can run wireshark on PC, and I will see, what AP is trying to send to our VPN servers? Is this approach correct, or I need to do something different?

Score:1
za flag

Most easy way would be to configure a monitoring session on a switch the AP is connected to, to send all the traffic to another port or vlan, where you can sniff it with a wireshark.

Check how this is done on Cisco Catalyst switches: configuring monitoring sessions on Catalyst switches

Similar technology applies to all other managed switches, but the configuration process depends on the vendor software.

mangohost

Post an answer

Most people don’t grasp that asking a lot of questions unlocks learning and improves interpersonal bonding. In Alison’s studies, for example, though people could accurately recall how many questions had been asked in their conversations, they didn’t intuit the link between questions and liking. Across four studies, in which participants were engaged in conversations themselves or read transcripts of others’ conversations, people tended not to realize that question asking would influence—or had influenced—the level of amity between the conversationalists.