Score:0

openvswitch: definition ens3f1 is not for us (backend 2)

cn flag

When I start netplan --debug generate, then following message at then end of the output is shown: openvswitch: definition ens3f1 is not for us (backend 2)


ens3f1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether 00:10:18:9c:5c:06 brd ff:ff:ff:ff:ff:ff
inet 172.16.1.2/24 brd 172.16.1.255 scope global noprefixroute ens3f1
   valid_lft forever preferred_lft forever
inet 10.10.194.205/28 brd 10.10.194.207 scope global dynamic noprefixroute ens3f1
   valid_lft 689761sec preferred_lft 689761sec
inet6 fe80::210:18ff:fe9c:5c06/64 scope link 
   valid_lft forever preferred_lft forever

The port ens3f1 is configured for dhcp in netplan yml file. Why do I receive 2x Ip addresses? It looks like backup is used. How can I remove this status for this port? Please see below. openvswitch service is not available(removed).

Thank you for your help, Susanne

us flag
Please show the netplan yaml in question.
mangohost

Post an answer

Most people don’t grasp that asking a lot of questions unlocks learning and improves interpersonal bonding. In Alison’s studies, for example, though people could accurately recall how many questions had been asked in their conversations, they didn’t intuit the link between questions and liking. Across four studies, in which participants were engaged in conversations themselves or read transcripts of others’ conversations, people tended not to realize that question asking would influence—or had influenced—the level of amity between the conversationalists.