I recently installed kubuntu 23.04 on this laptop which supports 120hz on my laptop screen but in display configuration it says it only supports 60hz. I tried wayland and x11.
This is the output of sudo get-edid | parse-edid
:
Attempting to use i2c interface
No EDID on bus 0
No EDID on bus 1
No EDID on bus 2
No EDID on bus 3
No EDID on bus 4
No EDID on bus 5
No EDID on bus 6
No EDID on bus 7
No EDID on bus 8
No EDID on bus 9
No EDID on bus 10
No EDID on bus 11
No EDID on bus 13
No EDID on bus 14
No EDID on bus 15
No EDID on bus 16
1 potential busses found: 12
256-byte EDID successfully retrieved from i2c bus 12
Looks like i2c was successful. Have a good day.
Checksum Correct
Section "Monitor"
Identifier ""
ModelName ""
VendorName "CSO"
# Monitor Manufactured week 0 of 2022
# EDID version 1.4
# Digital Display
DisplaySize 300 190
Gamma 2.20
Option "DPMS" "false"
Horizsync 229-229
VertRefresh 40-120
# Maximum pixel clock is 700MHz
#Extension block found. Parsing...
I only know about extension blocks of type 02h. PLEASE email me!
Something strange happened. Please contact the author,
Matthew Kern at <[email protected]>
EDIT 1: Whenever I boot through recovery mode on X11 it says that 91hz is the only supported refresh rate. When I restart and boot normally I can only select 60 hz.